EasyManuals Logo
Home>Stiga>Lawn Mower>P 901 C Series

Stiga P 901 C Series User Manual

Stiga P 901 C Series
Go to English
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #102 background imageLoading...
Page #102 background image
EN
ENGLISH
(Translation of the original instructions)
14 TROUBLESHOOTING
Problem Probable cause Solution
1. Starter motor does not run. Insuciently charged battery. Charge the battery.
Badly connected battery. Check connections
20A fuse blown Replace the fuse
2. The starter motor runs but
the engine does not start
With the ignition key in the
start position, starter motor
runs but the engine does not
start.
Fuel stopcock closed. Open the fuel stopcock.
Faulty fuel supply. - Check the level in the tank.
- Check the fuel lter.
Faulty ignition. - Check that spark plug cap is
securely tted.
- Check that the electrodes are
clean and have the correct gap.
3. Starting is dicult or the
engine runs erratically.
Carburetion problems. Clean or replace the air lter.
4. Weak engine performance
during cutting.
Forward speed too high in rela-
tion to cutting height.
Reduce the forward speed and/
or raise the cutting height.
5. The engine stops, without
any warning sound.
- No fuel.
- Try to restart the engine.
Fill up with fuel (if the problem
persists, contact an authorised
service centre).
6. Uneven cut. Check tyre pressure.
The cutting device is dull. Contact an authorised service
centre.
Forward speed too high com-
pared to height of grass.
Reduce the forward speed and/
or raise the cutting height.
Cutting device assembly is full
of grass.
- Wait for the grass to dry.
- Clean the cutting device
assembly
7. Abnormal vibrations during
use.
- The cutting devices are unbal-
anced.
- The cutting devices are loose.
- Loose parts.
- potential damages.
Contact an authorised service
centre for checks, replacements
or repairs.
8. With the engine running, the
machine does not move when
the drive pedal is pressed.
“Gear disengagement” lever in
disengaged position.
Put into gear.
If one of the problems listed below occurs, replace the pertinent fuse.
9. No electric function works.
The battery is charged.
20A fuse faulty. Replace the 20A fuse.
If problems persist after having performed the above operations, contact your dealer.
27

Table of Contents

Other manuals for Stiga P 901 C Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stiga P 901 C Series and is the answer not in the manual?

Stiga P 901 C Series Specifications

General IconGeneral
BrandStiga
ModelP 901 C Series
CategoryLawn Mower
LanguageEnglish

Related product manuals