EN
ENGLISH
(Translation of the original instructions)
7.6 SAFETY CHECKS
When testing the machine, verify that the results
of the safety checks match the results in the
following tables.
Always carry out the safety checks be-
fore use.
If any of the results fails to match the
indications provided in the following
tables, do not use the machine!
Take it to a service centre to be
checked and repaired if necessary.
7.6.1 General safety check
Object Result
Fuel lines and
connections.
No leaks.
Electrical cables All insulation intact.
No mechanical damage.
Unloading system. No losses in connection
points. All screws are tight.
Oil lines No leaks. No damage.
Drive the machine
forwards and in re-
verse and release
the drive pedal.
The machine stops.
Test driving No abnormal vibrations.
No abnormal sound.
7.6.2 Electrical safety check
Status Action Result
The parking
brake pedal is not
pressed.
Try to start it. The engine
does not
start.
Engine running. The operator
gets up from
the seat.
The engine
stops.
7.7 START-UP/WORKING
When using the machine, the bonnet
must be closed and locked.
Always use full gas when using the
machine.
When starting the machine wait 2 sec-
onds in the start position before start-
ing the engine.
1. Open the fuel stopcock (22).
2. Check that the spark plug leads are inserted
into their spark plugs.
3. Disconnect the power socket (12:A).
4. Do not keep your foot on the service/drive
brake pedal (11:D).
Cold start
For 2WD models
1. Put into gear (14:A1).
For 4WD models
1. Put into gear (15:A1-B1).
2. Engage the parking brake (11:B)
3. Move the accelerator to full throttle (12:E).
4. Close the choke (12:G1) (if applicable).
5. Turn the ignition key and start the engine.
Before operating the machine, wait a
few minutes to allow the oil to heat up.
Hot start
For 2WD models
1. Put into gear (14:A1).
For 4WD models
1. Put into gear (15:A1-B1).
2. Engage the parking brake (11:B)
3. Move the accelerator to full throttle (12:E).
4. The choke control must be pressed (12:G2)
(if applicable).
5. Turn the ignition key and start the engine.
To continue see the instructions given
in paragraph 7.7.1.
7.7.1 Run
To operate with the machine proceed as de-
scribed below:
• Fully press the pedal down (11:B) and release
it.
• Press the pedal (11:D) to drive the machine.
• Move to the work area.
• If front attachments are installed, activate the
power socket (12:A).
• Start work.
17
To Next Page
Loading...
