20
The four different heights of
the wheels allows you to
maintain a safe distance
between the cutting deck
edge and the ground.
To change the position,
unscrew and remove the
screw (2) and reposition the
wheel (1) with the spacer (3)
in the hole at the desired
height; then tighten the
screw (2) onto the nut (4) as far as possible.
This work is to be done to both
wheels, WITH THE ENGINE OFF AND THE BLADES DIS-
ENGAGED.
To start cutting:
– move the throttle to «FAST»;
– raise the cutting deck as high as possible; only use the
blade ( 4.5), on grass lawns, do not use the blades on
stony ground or when the grass is very high.
– start moving forwards on the grass very slowly and with
utmost caution, as already described;
– regulate the cutting height and speed ( 4.6) considering
the conditions of the lawn (the height, density and damp-
ness of the grass).
When cutting on sloping ground,
reduce your speed to ensure safe conditions
( 1.2 - 5.5).
Whatever the conditions, always reduce the speed if you
notice a drop in engine speed – if you travel too fast compared
WARNING!
WARNING!
to the amount of grass being cut, you will not be able to mow
the grass well.
Disengage the blades and raise the cutting deck as high as
possible whenever you need to get past an obstacle.
5.4.6 End of mowing
When you have finished mowing, disengage the blades, lower
the engine speed and ride the machine with the cutting deck
raised as high as possible.
5.4.7 End of work
Stop the machine, move the throttle to «SLOW» and turn off
the engine by turning the key to «OFF».
To avoid backfire, position the throttle
on «SLOW» for 20 seconds before stopping the engine.
When the engine has stopped,
close the fuel stopcock (1).
Always take
out the ignition key before leav-
ing the machine unattended!
To keep the
battery charged, do not leave the
key in the «ON» position or «HEADLIGHTS ON» when the
engine is not running.
IMPORTANT
WARNING!
WARNING!
EN
To Next Page
Loading...
Need help?
General
