EasyManua.ls Logo

Stiga stig

Stiga stig
65 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26 EN
3. INSTALLATION
3.4.3. PASSAGES AMONG DIFFERENT AREAS OF THE GARDEN
Procedure:
1. In the case of corridors, the distance between two dierent sections of the perimeter wire must be
Z ≥70 cm.
2. In case of passage between two dierent sections of cable Z <70 cm, the area (A) is to be
considered a"Closed Area" and cannot be reached by the robot lawn mower automatically.
NOTE: For programming the robot lawn mower relating to the conguration of the garden with
"Closed Area", see the procedure at Par. 3.7.5 "Closed Area".
3.5. COMPONENTS INSTALLATION
ELECTRICAL HAZARD:
Only use the battery charger
and power supply provided by
the manufacturer. Improper use
may cause electric shock and\or
overheating.
CAUTION:
The circuit supplied must be

switch (RCD) with an activation
current not exceeding 30 mA.
ELECTRICAL HAZARD:
A socket must have been
prepared near the installation
area to connect it to electricity.
Make sure that connection
to the power supply network
conforms to laws in force of the
Country where it is used.
ELECTRICAL HAZARD:
Connect the power supply only
at the end of all the installation
operations. If necessary during

general power supply.
Z
A

Related product manuals