29EN
3. INSTALLATION
3.5.3. CHARGING BASE INSTALLATION
CAUTION:
Danger of cutting hands.
CAUTION:
Danger of dust in
the eyes.
ELECTRICAL HAZARD:
Connect the power supply only at the end of
all the installation operations. If necessary
power supply.
Requirements and obligations:
• Flat land • Compact soil
• Charging base • Perimeter cable
• Power supply • Fixing pegs
• Screwdriver • Hammer
• Electrician's scissors • Gloves
• Glasses
GLOVES OBLIGATION:
Use protective gloves to avoid
cutting your hands.
GLASSES OBLIGATION:
Use safety glasses to avoid the
danger of dust in the eyes.
The charging base can be installed:
• aligned with the perimeter cable so that the robot can access it by navigating the perimeter cable
clockwise.
• perpendicular to the perimeter cable (check installation options in the STIGA Stig App).
Procedure:
1. Check the installation requirements as shown in Par. 3.3 .
2. If necessary, prepare the ground so that the surface of the charging base (A) is at the same level
as the lawn (B), the ground must be perfectly at and compact in order to avoid deformation of the
surface of the charging base.
A B
To Next Page
Loading...
Need help?
General
