WORKSHOP MANUAL
T...102/122 - TC...102/122
Map of functional units
This check is made with the tester operating as a Volt-
meter (Volts DC 0 ÷ 20), with the black ferrule on ter-
minal 17 and the red one on terminal 18 of the CN4
connector (1) of the wiring.
– The key in the «ON» position
The reading shows the battery voltage, which should
never go below 11 Volts.
TERMINAL BOARD SUPPLY CHECK
CHAPTER REVISION FROM ... PAGE
7.4 0 2018 1 of 1
Validity
General informations
Related topics
---
To Next Page
Loading...
