Stiga V 302 - 8. TROUBLESHOOTING

EN - 8
8. 
  SOLUTION
1. The starter motor does not
turn.
Insuciently charged battery. Recharge the battery.
Badly connected battery. Check the connections
2. The starter motor turns, but
the engine fails to start.
With ignition key in start
position, the starter motor
turns, but the engine fails to
start.
Fuel tap closed. Open the fuel tap.
Faulty fuel supply. - Check the level in the tank.
- Check the fuel lter.
3. Starting is dicult or the
engine runs erratically.
Carburation fault. Clean or replace the air lter.
4. Weak engine performance
during cutting.
Forward speed too high in
relation to the cutting height.
Reduce advancing speed and/or
increase the cutting height.
5. Engine stops for no apparent
reason.
- Fuel has run out.
- Try restarting the engine.
Top up the fuel (if the problem
persists, contact an authorised
service centre).
6. Irregular cutting. Check the tyre pressure
Cutting means sharpening is
reduced.
Contact an Authorised Service
Centre.
High advancing speed in relation
to the height of the grass to be
cut.
Reduce advancing speed and/or
increase the cutting height.
The cutting means assembly is
full of grass.
- Wait for the grass to dry.
- Clean the cutting means assembly.
7. Unusual vibrations during use. - Cutting means incorrectly
balanced.
- Cutting means loose.
- Loose parts.
- Possible damage.
Contact an Authorised Service
Centre for verications,
replacements or repairs.
8. When the engine is running,
the machine remains
stationary when the drive
pedal is pressed.
"Transmission disengagement"
lever in disengaged position.
Engage the transmission.
NOTE If problems persist after having performed the de-
scribed operations, contact your dealer.
NOTE For further problems not listed in the table, contact an au-
thorised service centre immediately.