Stihl 064

STIHL 064, 066 38
Top:
Fitting crankshaft Top. Top
Screwing service tool into position Unscrewing service tool ZS
Bottom:
1 = Threaded sleeve 5910 893 2420 Bottom: Bottom:
2 =
Sc
r
e
w
t
hr
ead
o
n
c
r
a
nk
s
h
a
f
t
stub
P
u
llin
g
c
r
a
nk
s
h
a
f
t
in
to
ba
ll
bea
rin
g
Fi
tt
in
g
c
r
a
nk
case
gas
k
et
- Coat bearing seat of crankshaft - Hold the service tool and crank- - Remove the service tool: Re-
stub at ignition end with oil and shaft steady and rotate the lease the spindle by turning it
position it in the bearing from the spindle clockwise until the ser- counterclockwise and then un-
inside of the crankcase. vice tool butts against the crank- screw the service tool counter-
case. clockwise.
- Screw the threaded sleeve onto
the crankshaft stub. - Pull the crankshaft into the bear- - Fit a new gasket on the ignition
ing as far as it will go by turning side of the crankcase.
the spindle clockwise.
Important: The connecting rod
must point toward the cylinder
flange while the crankshaft is
being installed.