Stihl 200 - Carrying Eye and Deflector Mounting; Carrying Eye Installation Procedure; Deflector Mounting Overview; Deflector Types Identification

24
English
FS 120, FS 200, FS 250
: Press down the trigger interlock (1)
and squeeze the throttle trigger (2)
(full throttle) – this sets the throttle
cable correctly.
: For position of carrying eye see
"Parts and Controls"
: Place the clamp (1) with the
tapped hole on the left-hand side
of the drive tube.
: Squeeze the two ends of the clamp
together and hold in that position.
: Insert M 6 x 14 screw (2).
: Line up the carrying eye.
: Tighten down the screw firmly.
* see "Guide to Using this Manual"
Mounting the deflector
1 = Deflector approved for all cutting
tools
2 = Deflector approved for use with
mowing heads only
: Place the deflector on the
gearhead.
: Fit the plate (3) and line it up.
: Insert M 5 x 18 screws and tighten
down firmly.
STOP
249BA017 KN
1
2
Fitting the Carrying Eye*
002BA142 KN
1
2
1
Mounting the Deflector
002BA102 KN
1
3
2
3