TS 410, TS 420
English
19
N Turn the guard so that it is in the
position shown (see picture)
N Screw in and tighten the stop pin (1)
N Move the adjusting lever (2) to
position A
N Screw in the bolt (3) and tighten up
N Unscrew the bolt (4) of the limit
stop (5)
N Remove the limit stop (5)
N Turn the "cast arm with guard" so
that the guard is on the outboard
side
N Insert limit stop (5) – align the hole
in the limit stop with the hole in the
cast arm
N Screw in the bolt (4) and tighten up
N Insert the square nut into the guide
in the guard and hold it in place
N Screw in the shorter banjo bolt (6)
and washer at the adjusting lever
and tighten up with the combination
wrench
Mount "cast arm with guard" – guard
on the outboard side
N Press the oblong holes (1) in the
"cast arm with guard" on to the
studs (2), guiding the ribbed V-belt
over the front pulley
N The belt tensioner (3) must sit close
to the lug (4)
N Fit the "starter cover with rewind
starter" (5) over the studs (2)
N Tighten up the nuts (6) by hand
N Push the V-belt guard (7) into place
N Screw in the bolt (8) and tighten up
Connect water connection
N Insert the longer banjo bolt (1)
through the connector (2) of the
water attachment – observe the
position of the connector
N Insert the square nut into the guide
in the guard and hold it in place
1
370BA074 KN
4 5
3
2
A
4
5
370BA075 KN
6
The belt action must run smoothly.
1
1
2
2
370BA008 KN
1
2
4
3
6
6
2
2
2
370BA051 KN
6
5
8
370BA077 KN
7
1
1
370BA078 KN
2
3
To Next Page
Loading...
