Stihl BF - Mounting the Attachment; Removing Gearbox or Attachment; Drive Shaft Projection Limit; Incorrect Drive Shaft Dimension

BF
English
11
If the plug comes out of the drive tube
when you pull off the cap:
N Push the plug into the drive tube as
far as stop.
Removing the gearbox or attachment
Remove any existing gearbox or
interchangeable attachment from the
basic power tool.
N Loosen the clamp screws (arrows)
on the gearbox housing – do not
remove them.
N Pull the gearbox off the drive tube.
If the drive shaft slips out of the tube
when you pull off the gearbox:
N Push the drive shaft into the tube.
The drive shaft must not project from the
tube more than L = 22 mm (7/8 in).
If dimension (L) is not correct:
N Apply slight pressure to the drive
shaft and rotate it slowly at the same
time until it can be pushed in to the
specified length.
002BA248 KN
228BA090 KN
FCS
228BA091 KN
FCS
FH/HL
228BA081 KN
FS
228BA083 KN
FS
228BA086 KN
HT
228BA082 KN
KB/KW
228BA089 KN
381BA015 KN
L