BF
English
10
WARNING
This interchangeable attachment is only
approved for use on a basic power tool
equipped with one of the following
handle systems:
– Bicycle handle
– Loop handle
Operation of this interchangeable
attachment is permitted only with the
following basic power tools:
Bike-handled or loop-handled machines
– STIHL FC 85
1)
, FC 95
1)
,
FC 110
1)
– STIHL FH 75
– STIHL FS 85
2) 3)
, FS 90, FS 110
3)
,
FS 120, FS 130, FS 200, FS 240,
FS 250
– STIHL HL 75, HL 100 The BF
attachment is not approved for use
on machines with a short drive tube.
Bike-handled or loop-handled machines
The following machines must be
retrofitted with a loop handle and, if
necessary, a carrying ring for a
harness/shoulder strap:
– HL 75, HL 100, all versions with 0°
gearbox. The BF attachment is not
approved for use on machines with
a short drive tube.
To retrofit the loop handle see chapter
on "Mounting the Loop Handle".
To retrofit the carrying ring – see "Fitting
the Carrying Ring".
WARNING
Combinations with basic power tools
other than those listed above are not
permitted since they may result in
accidents or serious personal injury.
Preparations for Mounting the
Attachment
WARNING
To reduce the risk of injury, always shut
off the engine before converting the
basic power tool.
NOTICE
Make sure the work area is clean before
mounting or removing the attachment.
N Rest the power tool on the machine
support.
Removing the protective cap
If a cap is fitted on the end of the power
tool's drive tube:
N Pull the protective cap off the end of
the drive tube and keep it in a safe
place.
Approved Basic Power Tools
1)
If necessary, retrofit machine with
carrying ring for a harness/shoulder
strap. To retrofit the carrying ring –
see "Fitting the Carrying Ring".
2)
Not approved for model FS 85 with
serial numbers from 2 49 848 196
up to 2 53 552 820
3)
Not approved for models FS 85 RX
and FS 110 RX
Mounting the Attachment
To Next Page
Loading...
