0458-459-8221-C
23
English
12 Shutting Off the Engine
► Turn the choke knob (4) to the position.
► Place your left hand on the housing and one foot on the
base plate.
► Pull the starter grip slowly with your right hand until you
feel it engage.
► Pull the starter grip quickly and allow the starter rope to
rewind several times until the engine runs.
► Do not pull out the starter rope to full length and do not let
the starter grip snap back. Guide it slowly back into the
housing so that the starter rope can rewind properly.
► Blip the throttle trigger (2). The Master Control Lever (1)
will move to the run position and the engine will settle
down to idle speed.
12.1 Shutting Off the Engine
To shut off the engine:
► Release the throttle trigger.
► Move the Master Control Lever (1) to the stop position .
The engine stops and the Master Control Lever springs
back to position when released.
13.1 Testing the Controls
Before starting work, confirm that the throttle trigger is
undamaged and functioning properly.
WARNING
To reduce the risk of serious or fatal injuries, always wear
proper clothing and protective apparel, including proper eye
protection, and keep bystanders out of the area while testing
the controls.
Stopping the Engine
► Start the engine, @ 11.
► Move the Master Control Lever to position .
The engine should stop and the Master Control Lever
should spring back to position when released.
► If the engine does not stop, move the choke knob to
position and have the unit repaired before use.
14.1 Using the Blower
WARNING
Always wear proper clothing and protective apparel,
including proper eye protection, @ 5.3. Never direct the air
flow toward bystanders. Keep bystanders at least 50 ft.
(15 m) away from the work area, @ 5.7.4. Work carefully
and maintain proper control of the blower.
The blower is designed for single-handed operation with the
right hand.
12 Shutting Off the Engine
1
0000-GXX-B950-A0
13 Checking the Blower
14 During Operation
To Next Page
Loading...
Need help?
General
Weight and Dimensions
