15BT 120 C
English / USA
Starting
: Press down the throttle trigger
interlock (1), squeeze the throttle
trigger (2) and hold them in that
position.
: Move the slide control (3) to START
and hold it there.
: Now release the throttle trigger,
slide control and throttle trigger
interlock in that order. This is the
starting throttle position.
: Set the choke knob (4):
To g if engine is cold.
To e if engine is warm.
(also use this setting if the engine
has been running but is still cold)
: Press the fuel pump bulb (5) at least
five times.
: Place the machine on the ground so
that it is secure.
: Put your right foot in the handle
frame and press down, left hand on
the handle frame.
: Pull the starter grip slowly with your
right hand until you feel it engage –
and then give it a brisk strong pull.
Do not pull out starter rope to full
length – it might break.
: Do not let the starter grip snap back
– guide it back into the housing so
that the starter rope can rewind
properly.
: Continue cranking until the engine
runs.
3
2
392BA027 KN
START
1
427BA007 KN
4
5
427BA008 KN
To Next Page
Loading...
Need help?
General
