Stihl FCB - Page 6

6
english / USA
FCB
THE EDGER
For illustrations and definitions of the
edger parts see the chapter on
“Parts and Controls“! See also the
chapter on “Parts and Controls“ of the
owner’s manual of the powerhead the
edger attachment is mounted on.
!Warning!
Never modify an edger in any way.
Only attachments supplied by STIHL or
expressly approved by STIHL for use
with the specific STIHL edger models
are authorized. Although certain un-
authorized attachments are useable for
the STIHL edger, their use may, in fact,
be extremely dangerous.
THE USE OF THE EDGER
Transporting the edger
!Warning!
Always turn off the engine and make
sure the cutting attachment has stopped
before putting an edger down. When
transporting your edger in a vehicle,
properly secure it to prevent turnover,
fuel spillage and damage to the edger.
Preparation for the use of the edger
Adjust carrying harness and hand grip to
suit your size before starting work.
The machine should be properly
balanced as specified in your owner's
manual for proper control and less
fatigue in operation.
Always check your edger for proper
condition and operation before starting,
particularly the throttle trigger, throttle
trigger interlock (and if applicable, stop
switch, cutting tool, deflector and
harness). An arrow on the deflector
shows the correct direction of rotation of
the cutting blade.
The deflector can be rotated to suit
working conditions. The arrow on the
deflector must always face away from
you, so that cuttings and other dedris will
be diverted away from the machine and
your position (see chapter "Working
Techniques").
The throttle trigger must move freely and
always spring back to the idle position.
The cutting tool must be properly
tightened and in safe operating
condition. Inspect for loose parts (nuts,
screws, etc.) and for cracked, bent,
warped or damaged blades.
Fueling
Your STIHL edger uses an oil-gasoline
mixture for fuel (see the chapter on
“Fuel“ of your owner's manual).
!Warning!
Gasoline is an extremely
flammable fuel. If spilled
or ignited by a spark or
other ignition source, it
can cause fire and serious
burn injury or property
damage. Use extreme caution when
handling gasoline or fuel mix.
Do not smoke or bring any fire or flame
near the fuel.
Fueling Instructions
Fuel your edger in well-ventilated areas,
outdoors. Use a fuel container
acceptable for the purpose.
002BA118 KN