FS 240, FS 240 R
English
8
Arrows on the deflector (A) and limit 
stop (B) (as seen from the underside) 
show the correct direction of rotation of 
the cutting attachment. When viewed 
from above, however, the cutting 
attachment rotates counterclockwise.
Some of the following symbols may be 
embossed on the outside of the deflector 
in order to indicate the approved 
combination of cutting attachment and 
deflector.
Adjust carrying harness and hand grip to 
suit your size before starting work. The 
machine should be properly balanced as 
specified in your instruction manual for 
proper control and less fatigue in 
operation. To be better prepared in case 
of an emergency, practice releasing the 
unit from the harness as quickly as 
possible.
Starting
WARNING
Start the engine at least 10 feet (3 m) 
from the fueling spot, outdoors only.
For specific starting instructions, see the 
appropriate section of your manual. 
Place the power tool on firm ground or 
other solid surface in an open area. 
Maintain good balance and secure 
footing.
WARNING
To reduce the risk of injury from blade or 
line contact, be absolutely sure that the 
cutting attachment is clear of you and all 
other obstructions and objects, including 
the ground, because when the engine 
starts at starting-throttle, engine speed 
will be fast enough for the clutch to 
engage and move the cutting 
attachment.
Once the engine has started, 
immediately blip the throttle trigger, 
which should release the starting throttle 
and allow the engine to slow down to 
idle.
With the engine running only at idle, 
attach the power tool to the spring hook 
of your harness (see appropriate 
chapter of this manual.)
The deflector may be 
used in combination with 
mowing heads.
The deflector may be 
used in combination with 
grass cutting blades.
The deflector may be 
used in combination with 
brush knives.
The deflector must not be 
used in combination with 
mowing heads.
The deflector must not be 
used in combination with 
grass cutting blades.
The deflector must not be 
used in combination with 
brush knives.
The deflector must not be 
used in combination with 
circular saw blades.
The deflector must not be 
used in combination with 
brush knives or circular 
saw blades.
The deflector must not be 
used in combination with 
grass cutting blades, 
brush knives or circular 
saw blades.