FS 260 C, FS 360 C
English
17
Permissible combinations
Choose the proper combination from the
table depending on the cutting
attachment!
Cutting attachments
Mowing heads
1 STIHL SuperCut 40-2
2 STIHL AutoCut 40-2
3 STIHL TrimCut 41-2
4 STIHL PolyCut 41-3
Metal cutting attachments
5 Grass cutting blade 230-4
6 Grass cutting blade 255-8
7 Brush knife 300-3
8 Circular saw blade 200 scratcher
tooth
9 Circular saw blade 200 chisel tooth
10 Circular saw blade 225 scratcher
tooth
11 Circular saw blade 225 chisel tooth
Deflectors, limit stops
Deflectors
12 Deflector only for mowing heads
13 Deflector for the mowing tools
Items 5 to 7
Limit stops
14 Limit stop for circular saw blades
200
15 Limit stop for circular saw blades
225
Harnesses
16 Full harness must be used
Mounting the bike handle with
swiveling handle support
The machine is supplied with the clamp
moldings (1) mounted to the
handlebar (2).
Mounting the control handle
N Take out the screw (3) and remove
the nut (4) from the control
handle (5).
For safety reasons only the
cutting attachments and deflectors
and/or limit stops within one line of
the table may be combined with
one another. Other combinations
are not permissible – risk of
accident!
Circular saw blades of other, non-
metal materials must not be used.
Warning!
Based on the cutting attachment being
used:
Choose the proper deflector in order to
reduce the risk of injury from thrown
objects and contact with the cutting
attachment.
Make sure your unit is equipped with the
proper handle and harness in order to
reduce the risk of injury from loss of con-
trol and contact with the cutting
attachment.
Use grass cutting metal blades, brush
knifes and circular saw blades on this
unit only if equipped with a bike handle.
Do not use rigid polymer blades on this
unit.
Mounting the Bike Handle
2
1
6BA018 KN
3
4
5
002BA352 KN
To Next Page
Loading...
Need help?
General
