Stihl FS 36 - Using the Cutting Tools; STIHL Polycut Mowing Heads; STIHL Autocut Mowing Head

%ORFNLQJWKHVKDIW
 Insert locking pin in
 holes in deflector and thrust plate,
turning the latter back and forth until
the shaft blocks -
)LWWLQJWKHFXWWLQJKHDG
.HHSWKHLQVWUXFWLRQVKHHW
VXSSOLHGZLWKWKHFXWWLQJKHDGLQ
DVDIHSODFH
67,+/$XWRFXW
 Slide upper part
 onto shaft and fit
 hexagon socket
 over hexagon –
 Place cap on upper part - turn
clockwise as far as possible on the
shaft and tighten securely
67,+/3RO\FXW
IRU)6RQO\
 Screw cutting head as far as
possible clockwise on
 the shaft -
•
Block the shaft -
•
Tighten the cutting head securely.
,PSRUWDQW
Remove the locking pin!
342BA021 KN
1
2
2
3
2
5
342BA022 KN
1
4
2
6
342BA023 KN
 )6