Stihl FS 36 User Manual

•
Check film of lubricant at
regular intervals - about every 50
hours of operation if you use your
power edger daily or once a year if
you are an occasional user.
•
Release clamp on deflector -
pull off the deflector.
•
Release clamp  on gear housing.
•
Take out the fixing screw .
•
Pull off the bearing housing .
•
Pull the flexible shaft  out of the
drive tube.
,IVKDIWKDVWXUQHGEOXH
ILWDQHZRQH
•
Use STIHL multipurpose grease
0781 120 1109 to coat dry areas
of the shaft -
•
Push shaft into the drive tube -
turn it back and forth until distance
$ is less than 15 mm (0.6").
•
Push bearing housing onto drive
tube -
turn output shaft back and forth.
•
Line up holes for fixing screw.
•
Insert and tighten down the fixing
screw.
•
Tight the clamp on the bearing
housing.
•
Mount the deflector -
as described in "Assembling the
Trimmer".
000BA036 TR
1
Always press spark plug boot  snugly
onto spark plug terminal  of the pro-
per size. (Note: If terminal has
detachable SAE adapter nut, it must be
attached.) A loose connection between
spark plug terminal and ignition wire
connector in the boot may create arcing
that could ignite combustible fumes and
cause a fire.
/XEULFDWLQJWKH)OH[LEOH
6KDIW
342BA039 KN
1
2
3
5
4
342BA040 KN
)6 

Stihl FS 36 Specifications

General

Engine Power	0.8 kW
Engine Type	2-stroke
Fuel Tank Capacity	0.33 L
Shaft Type	Straight
Displacement	27.2 cc
Starter System	Recoil