Stihl FS 360 C-M User Manual

FS 360 C-M, FS 410 C-M, FS 460 C-M, FS 490 C-M
English
5
– Safety devices (e. g., deflector for
cutting attachments, rider plate) for
damage and/or wear. Always
replace damaged parts. Do not use
the machine with a damaged
deflector or worn rider plate (if the
writing and arrows are no longer
discernible)
– Never attempt to modify the controls
or safety devices.
– Keep the handles dry and clean –
free from oil and dirt – this is
important for safe control of the
machine
– Adjust the harness and handle(s) to
suit your height and reach Note the
information in the chapters "Fitting
the Harness" and "Balancing the
Machine".
To reduce the risk of personal injury, do
not operate your power tool if it is
damaged or not properly assembled!
To prepare for emergencies when using
a harness: Practice setting down the
machine quickly. To avoid damage, do
not throw the unit to the ground when
practicing.
Starting the engine
Start the engine at least 3 meters from
the fueling spot, outdoors only.
Place the unit on firm ground in an open
area. Make sure you have good balance
and secure footing. Hold the unit
securely. The cutting attachment must
be clear of the ground and all other
obstructions because it may begin to run
when the engine starts.
This is a one-person machine – ensure
that there is no-one within 15 meters of
the machine, not even when starting the
power tool! Risk of injury due to ejected
objects!
Keep easily combustible materials
(e. g., wood chips, bark, dry grass, fuel)
away from hot exhaust gases and hot
muffler surfaces – risk of fire!
Holding and guiding the machine
Always hold the unit firmly with both
hands on the handles.
Make sure you always have a firm and
secure footing.
Right hand on control handle, left hand
on grip on handlebar.
While working
Make sure you always have a firm and
secure footing.
In the event of imminent danger or in an
emergency, push the stop switch to stop
the engine.
There is a risk of accident from ejected
objects within a wide area around the
working space, so you must ensure that
there is no-one within a 15 m radius of
the machine. This distance must also be
maintained in relation to objects
(vehicles, window panes) – risk of
property damage! Even at distances
beyond 15 m, the danger cannot be
ruled out.
Check that the engine is properly idling
so that the cutting tool will not continue
rotating after you release the throttle
trigger. If the cutting attachment still
rotates at idle speed, have your dealer
make proper adjustments or repairs.
STIHL recommends you have this work
done by a STIHL servicing dealer.
Take special care in slippery conditions
– damp, snow, ice, on slopes or uneven
ground.
Watch out for obstacles: tree stumps,
roots – risk of tripping or stumbling!
Only work while standing on the ground,
never on a ladder, work platform or other
unstable surface.
Avoid contact with the
cutting attachment – risk
of injury!
Do not drop-start the
power tool – start the
engine as described in
the User Manual. The
cutting attachment runs
on for a short while after
releasing the throttle trig-
ger – coasting effect!
002BA480 KN
15m (50ft)

Stihl FS 360 C-M Specifications

General

Brand	Stihl
Model	FS 360 C-M
Category	Trimmer
Language	English