EasyManua.ls Logo

Stihl FS 511 C-M - Starting and Stopping the Engine

Stihl FS 511 C-M
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
If you mix the fuel yourself, use only STIHL two-
stroke engine oil or another high-performance
engine oil in accordance with JASO FB, JASO
FC, JASO FD, ISO-L-EGB, ISO-L-EGC or ISO-L-
EGD.
STIHL specifies STIHL HP Ultra two-stroke
engine oil or an equivalent high-performance
engine oil in order to maintain emission limits
over the machine’s service life.
Make sure that the octane number of the gas‐
oline is at least 90 RON and the ethanol con‐
tent is not more than 10%.
Make sure the two-stroke engine oil you are
using meets the requirements.
Depending on the desired amount of fuel,
determine the correct amounts of two-stroke
engine oil and gasoline in a mixing ratio of
1:50. Examples for fuel mixes:
20 ml Two-stroke engine oil, 1 l gasoline
60 ml Two-stroke engine oil, 3 l gasoline
100 ml Two-stroke engine oil, 5 l gasoline
Pour two-stroke engine oil into a clean
approved fuel canister first and then add gaso‐
line.
Stir the fuel before topping up.
8.2 Fueling the Trimmer
Shut off the engine.
Place your trimmer on a level surface so that
the fuel tank cap faces up.
Use a damp cloth to clean the tank cap and
the area around it.
Turn the tank cap counterclockwise until it can
be removed.
Remove the fuel tank cap.
NOTICE
Bright light, sunlight and extreme tempera‐
tures can cause the fuel mix to separate much
faster. The trimmer can be damaged if it is
used with a fuel mix that has become separa‐
ted.
Thoroughly mix the fuel.
Do not use fuel mix that has been stored for
more than 30 days.
Fill the tank to within no more than 15 mm
of the brim, taking care not to spill any fuel.
Fit the tank cap on the tank opening.
Turn the tank cap clockwise and tighten it
down firmly by hand.
The fuel tank is closed.
9 Starting and Stopping the
Engine
9.1 Starting the engine
Place the trimmer on a level surface so that
the cutting attachment does not touch the
ground or other objects.
Remove the transport guard.
3
4
1
2
0000097401_001
Depress the manual fuel pump (1) at least 5
times.
If the engine is warm: Leave the choke lever
(2) in position
.
If the engine is at ambient temperature: Push
in the choke lever (2) at the edge and set it in
position
.
9 Starting and Stopping the Engine English
0458-856-0121-A. VA0.B21. 15

Related product manuals