FS 70 RC
English
26
Version with Loop Handle
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and 0 = Stop
positions.
Function of Stop Switch and Ignition
System
The stop switch is normally in the Run
position: Ignition is on in this position –
the engine is ready to start and may be
started. If the stop switch is moved to
the 0 position, the ignition is switched
off. It is automatically switched on again
after the engine comes to a standstill.
Starting the Engine
N Press the fuel pump bulb (4) at least
five times – even if the bulb is filled
with fuel.
Cold Engine (cold start)
N Press in the choke lever (5) and turn
it to g at the same time.
Warm Engine (warm start)
N Press in the choke lever (5) and turn
it to < at the same time.
Also use this setting if the engine has
been running but is still cold.
Cranking
N Place the unit on the ground: It must
rest securely on the engine support
and the deflector. Check that the
cutting attachment is not touching
the ground of any other obstacles.
N Make sure you have a safe and
secure footing.
N Hold the unit firmly on the ground
with your left hand and press down
– do not touch the throttle trigger or
lockout lever.
NOTICE
Do not stand or kneel on the drive tube.
To Next Page
Loading...
