Stihl FSE 31 - Handle and Grip Safety; General Operational Safety; Electrical Connection Safety; Power Cord Management

FSE 31, FSE 41
English
5
–
Keep the handles dry,
clean and free from dirt, for
safe control of the power
tool
– Adjust handle to suit your
height and reach.
To reduce the risk of
accidents and personal injury,
do not operate your power tool
if it is not properly assembled
and in good condition!
Do not operate your power
tool if any of its components
are damaged or not properly
mounted.
Never attempt to modify the
controls or safety devices
Before switching on your
power tool, make sure the
cutting attachment is not
touching the ground or any
other object.
Electrical connection.
Reduce the risk of electric
shock:
– Voltage and frequency of
the machine (see rating
plate) and the voltage and
frequency of your power
supply must be the same.
– Examine the connecting
cord, power plug and
extension cord for
damage. Damaged cords,
couplings and plugs or
connecting cords that do
not comply with the
regulations must not be
used
– Always connect the engine
analyzer to a properly
installed wall outlet.
– Check that the insulation of
the power cord, extension
cord, plug and coupling is
in good condition
– Never touch the power
plug, power cord and
extension cord, and
electrical plug connections
with wet hands.
– Any extension cords used
must comply with the
specifications for the
particular application
Position the connecting and
extension cords correctly:
– Check minimum cross
section of wires (wire
gauge) – see "Connecting
to Power Supply".
– To reduce the risk of
stumbling, position and
mark the connecting cord
so that it cannot be
damaged or endanger
others.
– Using unsuitable extension
cords can be dangerous.
Use only extension cords
approved for outdoor use
which are labeled as such
and have the appropriate
wire gauge.
– The plug and coupling of
the extension cord must be
water-proof and must
never be immersed in
water.
– Do not chafe on edges,
pointed or sharp objects
– don't trap or squeeze the
cord in or under doors or
windows
– If cords are twisted –
unplug the power tool and
straighten them out
Avoid contact with
the cutting attach-
ment – risk of
injury!
Note that the cut-
ting attachment
continues to run for
a short period after
the power tool is
switched off – fly-
wheel effect.