Stihl FSE 81 - Removing Remaining Nylon Line; Disengaging and Removing Spool; Winding Line Onto Spool (Model 5-2); Winding STIHL AutoCut 5-2 Spool

18
English
FSE 60, FSE 71, FSE 81
Removing Remaining Nylon Line
: Open the mowing head – hold it
steady with one hand and unscrew
the cap (1) counterclockwise.
: Disengage the spool (2), take it out
of the mowing head and remove the
remaining nylon line.
Winding Line Onto Spool
A prewound spool** may be
installed instead of fitting individual
lines.
** see "Special Accessories"
: Use green-coded nylon line with a
diameter of 2 mm.
: Cut two 3 m lengths of nylon line
from the replacement reel**
Insert the end of each line (3) in the
holes (4) in the spool.
: Bend the ends of the lines over the
edge of the holes to form a hook.
** see "Special Accessories"
: Straighten out the nylon lines and
wind them tightly onto the spool –
one nylon line in each chamber.
: Engage the ends of the nylon lines
in the notches (5).
Assembling the Mowing Head
Check that the compression spring
is installed (see "Mounting the
Mowing Head").
681BA008 KN
1
2
681BA009 KN
4
3
3
681BA010 KN
5
5