Do you have a question about the Stihl FSE 81 and is the answer not in the manual?
Type | Brush cutter |
---|---|
Head type | Nylon line |
Handle type | D-loop handle |
Product color | Orange, White |
Sound power level | 93 dB |
Power cable length | 0.5 m |
Vibration emission | 2.9 m/s² |
Automatic line feed | Yes |
Sound pressure level | 83 dB |
Cutting diameter (max) | 350 mm |
Power source | AC |
AC input voltage | 230 V |
Length | 1530 mm |
---|---|
Weight | 4700 g |
Explains symbols and text conventions used in the manual for clear instructions.
Covers reading manual, regulations, operator health, and accountability for safety.
Details avoiding impairment, proper use, no modifications, and cord safety.
Details required protective clothing and equipment like sturdy clothes, shoes, eye protection, and gloves.
Instructions for safely switching off, unplugging, and carrying the unit.
Covers assembly, condition, voltage/frequency match, cord checks, splash-proof receptacles, and tool/deflector approval.
Details positioning cords to avoid damage, using grounded outlets, and checking cord condition.
Emphasizes firm grip, stable footing, and holding machine on right-hand side.
Covers immediate shutdown in emergencies and maintaining a 15m safety distance.
Warns against water, wet conditions, and advises caution on slopes and poor visibility.
Never operate without deflector; inspect area for debris that can be thrown.
Proper cord positioning, avoiding chafing, and unwinding from drums.
Replace damaged tools, clean residue, avoid modifying tools, and switch off before replacement.
Always switch off and disconnect power before maintenance; do not attempt unauthorized repairs.
Recommends authorized dealers for service and using genuine STIHL replacement parts.
Covers cleaning plastic parts, avoiding water spray, checking cord insulation, and tightening screws.
Select combinations from table; only shown versions are permitted due to safety risks.
Mowing heads (1, 2) only for trimmers with curved drive tube and loop handle.
Steps for fitting the drive tube into the motor housing and securing it.
Steps for attaching the loop handle to the drive tube and adjusting its position.
Steps for attaching the deflector to the trimmer body using screws and locknuts.
Steps for sliding the mowing head onto the shaft and engaging the hexagon recess.
Instructions for fitting the spring, winding nylon lines, and threading them through sleeves.
Steps for pushing the mowing head onto the shaft and securing the cap.
Specifies matching mains and operating voltage, and using a ground-fault circuit interrupter.
Details minimum conductor cross-section requirements for extension cords based on length.
Explains tapping the head to advance line and how the deflector trims it.
Instructions for wearing the harness over the shoulder and adjusting length.
Steps for creating a loop for strain relief and connecting to the power outlet.
Steps for safe startup including footing, grip, and control operation.
How to safely turn off the machine and awareness of the flywheel effect.
Guidelines for both short-term security and long-term dry storage to prevent hazards.
Steps to remove the cap and spool to access the line.
Instructions for fitting the spring, spool, and checking for engagement.
Steps for winding 2m nylon lines onto the spool and threading them through the head.
How to unscrew the cap and remove the spool to take out the line.
Steps for winding 3m nylon lines and engaging ends in notches.
Check compression spring and ensure spool snaps into position.
Table outlining maintenance tasks and intervals for various machine components.
Illustrates and labels all main parts and controls of the trimmer.
Lists motor, voltage, frequency, power, dimensions, and weight specifications.
Covers user maintenance, dealer repairs, and recommendations for genuine parts.
Provides measured vibration levels for the left and right handles according to ISO 8662.
Instructions for recycling electrical appliances and accessories properly.