Why Stihl HSE 81 motor does not run?
If the motor of your Stihl Trimmer doesn't run, it could be due to several reasons: * There's no power reaching the unit. * The connecting cord, plug, coupling, or switch is faulty. * The carbon brushes are worn. To address this, start by checking the fuse. Also have an electrician check and replace any faulty cords, plugs, or switches. If the carbon brushes are worn, replace them.
What to do if Stihl Trimmer cutting performance unsatisfactory?
If the cutting performance of your Stihl Trimmer is unsatisfactory, the most likely cause is dull cutting blades. Sharpening the blades should resolve this issue.
What to do if Stihl HSE 81 cutting blades do not move freely?
If the cutting blades of your Stihl Trimmer do not move freely, it's likely because the blades are dirty or loaded with resin. Cleaning the blades should solve this. If necessary, use a resin solvent.
Why Stihl Trimmer blades continue to coast when switched off?
If the blades of your Stihl Trimmer continue to coast without being braked when the unit is switched off, it could be due to: * A missing or improperly installed switch pin. * An improperly assembled control unit. To fix this, ensure the switch pin is properly installed and that the control unit is correctly assembled.
General| Blade size | 700 mm |
|---|---|
| Blade type | Double blade |
| Cutting length | 500 mm |
| Sound power level | 96 dB |
| Vibration emission | 2.9 m/s² |
| Sound pressure level | 85 dB |
| Engine power | 650 W |
| Power source | AC |
| AC input voltage | 230 - 240 V |
Weight and Dimensions| Depth | 1330 mm |
|---|---|
| Weight | 4100 g |
Emphasizes observing local safety regulations and using qualified electricians for repairs.
Steps for removing and installing carbon brushes to maintain electrical contact.
Steps for removing the old motor and fitting a new one, including wire connections.
Steps to disassemble and mount the complete cutting attachment.
Specific guidance and scale settings for sharpening the hedge trimmer blades.
Steps for exposing, removing components, assembling, and installing the main drive gear.
Procedures for properly closing and reassembling the tool's housing.
Guide to diagnosing and resolving common problems encountered with the tool.
To Next Page
