Stihl HSE 81

43HSE 61, HSE 71, HSE 81
6.5.2 Installing the housing
: Install the power cord (1) with
terminal block (2).
: Fit the push nuts (1).
1
2
1
1
: Before fitting the gear housing
with its components, push the
blue wire (1) into the two slots (2)
and make sure it is secure.
: Place the gear housing (1) with
its components in the motor
housing (2).
1
2
2
1
2
– Assemble the rear handle,
b 6.4.3.
– Close the rear handle, b 6.4.4.
– Install the drive gear, b 5.1.5.
– Close the housing, b 6.2.