English
135
0
Version
The angle
of
th
cutter bar can
be
adjusted upwards in 4 stages from 0°
(straight) to 45°, and downwards in 8
stages from
0°
to
90° (right angle facing
down). There are therefore 13 possible
working positions.
There is also a special transport position
for the cutter bar.
A-··To
reduce
the
risk
of
injury,
Lll"~ffyoume
adjUlltme1'iioiilY
when the cutting blades are at a
standstill-
engine at idle speed.
l'
The gearbox becomes hot during
Ll..l. operation. To reduce
the
risk
of
burn
injury,
do not touch the gear
housing.
10
*
To
reduce the
risk
of
injury,
Ll..l.
never touch the blades while
making adjustments.
• Pull back the sliding sleeve (1) and
use the lever (2)
to
adjust the joint
by one or several holes.
• Release the sliding sleeve (1) and
make sure the lock pin engages the
quadrant (3).
The sliding sleeve butts against the
housing when the pin is properly
engaged (after making adjustment).
Transport
Position
The Gutter
barcanbe
(olded (Ialagainst
the drive tube and locked
in
position to
save space during transportation.
h..
To
reduce the
risk
of
injury,
Lllalways
shut off the engine - move
slide control
to
STOP
or
stop
switch to
0 - and fit the blade
scabbard before moving the cutter
bar
to
the transport position or
from the transport position to the
normal working position.
* The gearbox becomes hot during
Ll..l.
operation.
To
reduce
the
risk
of
burn
injury, do not touch the gear
housing.
HL-KM
----_._--_.--
-
To Next Page
Loading...
Need help?
General
