English
~
f-----;
• Attach the carabiner (1) to the
carrying ring (2) - hold the carrying
ring steady.
• Check that the carabiner is at about
hip height - adjust
if
necessary.
Detaching
the
unit
from
the
harness
1
• Press down the bar
on
the
carabiner (1)
and
pull the carrying
ring (2) out
of
the carabiner.
12
Starting
the
Engine
Always follow the oper.ting instructions
for the KombiEngine and basic power
tool.
• Position the unit securely for
starting:
It must rest
on
the machine
support and the blade gearbox.
• On units with adjustable cutter bar:
Set the cutter bar to the straight
(0')
position.
•
RemtMHhe
blade scabbard. Check
that the cutting blades are not
touching the ground or any other
obstacles.
If necessary, rest the
gearbox on a raised support (e.g,
mound, brick or something similar).
• Make sure you have a safe and
secure footing.
• Hold the unit
firmly
on the ground
with your left hand and press down
- do not touch the throttle trigger or
interlock lever.
I
~
I
Do
not stand or kneel on the drive
"'"
tube.
I/' The cutting attachment
may
begin
~
to
move
as
soon
as
the
engine
starts. For this reason, blip the
throttle after starting - the engine
returns
to
idling speed.
The
start'lng procedure is now as
described
in
the instruction manual
of
the KombiEngine or basic power tool
you are using.
Shut
off
the
engine.
• See instruction manual
of
the
KombiEngine or basic power tool.
HL-KM
f
Ii
I
To Next Page
Loading...
Need help?
General
