Stihl HSE 42 - Maintenance and Care

HSE 42, HSE 52
English
10
Maintenance and Care
The following intervals apply for normal operating conditions. The specified intervals must
be shortened accordingly when working for longer than normal or under difficult cutting
conditions (extensive dust, etc.).
Before starting work At the end of work and/or daily Weekly Monthly Annually If faulty If damaged As required
Complete machine
Visual inspection X
Clean X
Two-hand control
Check function – blades must quickly come
to a standstill when the trigger switch or
switch lever is released
X
Cool air intake port
Visual inspection X
Clean X
Cutting blades
Visual inspection X
Clean
2)
X
sharpen
1)2)
X
Have replaced by servicing dealer
1)
X
Gearbox and connecting rod
inspection by a specialist dealer after every
50 hours of operation
1)
Have gearbox topped up with STIHL gear
lubricant by servicing dealer
1)
X
Carbon brushes
inspection by a specialist dealer after every
100 hours of operation
1)
Have replaced by servicing dealer
1)
X
Accessible screws, nuts and bolts Tighten X
Safety information label replace X
1)
STIHL recommends STIHL dealers
2)
Afterwards spray the blades with STIHL resin solvent