HTA 65, HTA 85
English
30
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
N Use a dry brush or similar tool to
clean the cooling slots at regular
intervals.
N Move the retaining latch to ƒ.
N Remove the battery.
N Remove the saw chain and guide
bar, clean them and spray with
corrosion inhibiting oil.
N Thoroughly clean the machine,
especially the cooling air inlets.
N If you use a biological chain and bar
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
N Store the machine in a dry and
secure location – out of the reach of
children and other unauthorized
persons.
Cover for battery compartment (special
accessory)
The cover prevents dirt falling into the
empty battery compartment.
N After finishing work, slide the
cover (1) home until it engages
audibly in position.
Motor Cooling
0022BA028 AS
Storing the Machine
To Next Page
Loading...
