19KM 85, KM 85 R
english / USA
When engine begins to fire
: Set the choke lever to e and
continue cranking.
As soon as engine runs
: Blip the throttle trigger so that the
slide control moves to the normal
run position # and the engine settles
down to idle speed.
Make sure the carburetor is
correctly adjusted – the tool must
not move when the engine is idling.
Your machine is now ready for
operation.
To shut down the engine:
: Move the slide control in direction of
arrow (c) to STOP-O.
At very low outside temperatures
As soon as engine runs:
: Blip the throttle trigger to disengage
the starting throttle position. The
slide control moves to the normal
run position # and the engine settles
down to idle speed.
: Open the throttle slightly.
: Warm up engine for brief period.
If the engine does not start
If you did not turn the choke knob to e
quickly enough after the engine began to
fire, the combustion chamber has
flooded.
: Turn choke knob to e
: Set slide control, interlock lever and
throttle trigger to starting throttle
position.
: Start the engine by pulling the
starter rope firmly. 10 to 20 pulls
may be necessary.
If the engine still does not start
: Move the slide control in direction of
arrow (c) to STOP-O.
: Remove the spark plug boot (10).
: Unscrew and dry off the spark plug.
: Open the throttle wide.
: Crank the engine several times with
the starter to clear the combustion
chamber.
: Refit the spark plug. Connect the
spark plug boot (press it down
firmly).
: Move slide control to START.
: Set the choke lever to e, even if the
engine is cold.
: Now start the engine.
Fuel tank run until dry
: After refueling, press the fuel pump
bulb at least five times – even if bulb
is filled with fuel.
: Set the choke lever according to
engine temperature.
: Now start the engine.
393BA019 KN
10