7KM 85, KM 85 R
english / USA
Screw Cap
!Warning!
Unit vibrations can cause 
an improperly tightened 
fuel filler cap to loosen or 
come off and spill 
quantities of fuel. In order 
to reduce the risk of fuel 
spillage and fire, tighten the fuel filler cap 
by hand with as much force as possible.
Operating instructions
! Warning!
Improper use of any power tool can 
cause serious or fatal personal injury. To 
reduce the risk of personal injury to the 
operator from operating the power tool 
always follow the safety instructions on 
operating the power tool as provided in 
the owner’s manuals of the 
CombiEngine and the CombiTool.
Starting
!Warning!
Your power tool is a one-person 
machine. To reduce the risk of injury, 
keep bystanders out of your working 
area (see CombiTool manuals for 
specific distances). 
Stop the engine and cutting tool 
immediately if you are approached. Start 
and operate your power tool without 
assistance. For specific starting 
instructions, see the appropriate section 
of your manuals. Place the power tool on 
firm ground or other solid surface in an 
open area. Maintain a good balance and 
secure footing.
!Warning!
To reduce the risk of injury from loss of 
control, be absolutely sure that the 
working tool is clear of you and all other 
obstructions and objects, including the 
ground, because when the engine starts 
at starting-throttle, engine speed will be 
fast enough for the clutch to engage and 
move the working tool.
!Warning!
When you pull the starter grip, don't 
wrap the starter rope around your hand. 
Do not allow the grip to snap back, but 
guide the starter rope to rewind it 
properly. Failure to follow this procedure 
may result in injury to hand or fingers 
and may damage the starter 
mechanism.
See also the Safety Instructions on 
Starting in the owner’s manual of the 
CombiTool.
Muffler
!Warning!
Do not operate your power tool if the 
muffler is damaged, missing or modified. 
Such a muffler could cause an increase 
in heat radiation or sparks, thereby 
increasing the risk of fire or burn injury. 
You may also permanent damage the 
engine.
!Warning!
The muffler and other parts of the engine 
(e.g. fins of the cylinder, spark plug) 
become hot during operation and remain 
hot for a while after stopping the engine. 
To reduce risk of burns do not touch the 
muffler and other parts while they are 
hot. 
!Warning!
To reduce the risk of fire or burn injury, 
keep the area around the muffler clean. 
Remove all debris such as pine needles, 
branches or leaves when the engine is 
off and cooled.