MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English
59
Cooling inlets Clean X
Cylinder fins Clean XX
Carburetor
Check idle adjustment – chain must not rotate XX
Readjust idle X
Spark plug
Readjust electrode gap X
Replace after 100 hours of operation
All accessible screws and nuts (not adjusting
screws)
2)
Retighten X
Spark arresting screen in muffler (not all markets)
Check
1)
X
Clean, replace if necessary
1)
X
Chain catcher
Check X
Replace X
Safety labels Replace X
1)
STIHL recommends a STIHL servicing dealer.
2)
Firmly tighten down the cylinder base screws of professional saws (3.4 kW or more) after 10 to 20 hours of operation.
The following maintenance intervals apply for normal operating conditions only. If your daily working
time is longer or operating conditions are difficult (very dusty work area, resin-rich wood, tropical
wood, etc.), shorten the specified intervals accordingly. If you only use the saw occasionally, extend
the intervals accordingly.
before starting work
after finishing work or daily
after each refueling stop
weekly
monthly
every 12 months
if problem
if damaged
if required
To Next Page
Loading...
Need help?
General
