MS 241 C-M
English
36
All models
N Push the hand guard (1) forward –
the chain is locked.
N Depress the throttle trigger
lockout (2) and throttle trigger (3)
and hold them in that position –
move Master Control lever (4) to
start position (}) and let go of the
throttle trigger and throttle trigger
lockout at the same time.
N Hold and start your saw as
described.
As soon as the engine runs
N Press down trigger lockout and the
pull the throttle trigger (3) at the
same time – the Master Control
lever (4) moves to the run
position (F) and the engine settles
down to idling speed.
N Pull the hand guard back towards
the front handle.
The chain brake is now disengaged –
your saw is ready for operation.
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the clutch and chain
brake.
At very low outside temperatures
N Change over to winter operation if
necessary – see “Winter Operation”.
Stopping the Engine
N Move the Master Control lever in the
direction of STOP or † – when
released, the Master Control lever
springs back to the normal run
position F.
If engine does not start
N Check that all settings are correct.
N Check that there is fuel in the tank
and refuel if necessary.
N Check that the spark plug boot is
properly connected.
N Repeat the starting procedure.
or:
It is possible that the fuel-air mixture in
the combustion chamber is over-rich
and has flooded the engine.
N Remove the spark plug – see
"Spark Plug".
N Dry the spark plug.
To Next Page
Loading...
