MS 241 C-M
English
38
Long-term storage
See "Storing the machine"
Varying cutting lengths, types of wood
and work techniques require varying
amounts of oil.
The oil flow can be adjusted as needed
using the adjusting screw (1) (on the
bottom of the machine).
Ematic position (E), medium oil flow –
N Turn adjusting screw to E (Ematic
position)
To increase oil flow –
N turn the adjusting screw clockwise
To reduce oil flow –
N turn the adjusting screw
counterclockwise
NOTICE
The saw chain must always be coated
with oil.
N Turn the guide bar over – every time
you sharpen the chain and every
time you replace the chain – this
helps avoid one-sided wear,
especially at the nose and
underside of the bar.
N Regularly clean the oil inlet hole (1),
the oilway (2) and the bar groove
(3).
N Measure the groove depth – with the
scale on the filing gauge (special
accessory) – in the area used most
for cutting.
Oil Quantity Control
To Next Page
Loading...
