Stihl MS 251 C-Q User Manual

MS 251 C-Q
English
18
Continue the felling cut on the other side
of the trunk.
Make sure the second cut is at the same
height as the first cut.
N Engage the spiked bumper behind
the hinge and use it as a pivot –
avoid repositioning the saw more
than necessary.
N The guide bar nose enters the
wood (4) before it reaches the
holding strap – hold the saw
horizontally and swing it as far as
possible.
N Enlarge felling cut as far as
hinge (5).
– Do not cut into the hinge.
N Enlarge felling cut as far as holding
strap (6).
– Do not cut into the holding strap.
Shout a second warning immediately
before the tree falls.
N Cut through the holding strap at a
downward angle from outside with
outstretched arms.
A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the chain saw.
– The pitch (t) of the saw chain (1),
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
– The drive link gauge (2) of the saw
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
001BA268 KN
Cutting Attachment
001BA248 KN
1
2
3
a

Stihl MS 251 C-Q Specifications

General

Brand	Stihl
Model	MS 251 C-Q
Category	Chainsaw
Language	English