MS 362
English
40
If groove depth is less than specified:
N Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
The air filter system can be adapted to
suit different operating conditions by
installing a choice of filters. Changing
the filter is quick and simple.
The saw comes standard with either a
fleece filter or a fabric filter.
Fleece filter with felt prefilter
For normal, dry and very dusty work
areas.
Fabric filter
For severe winter conditions (e.g.
powder and drifting snow, frost).
If there is a noticeable loss of engine
power
Removing the shroud
N Move the Master Control lever to the
stop position (0).
N Push the hand guard forward – the
chain is locked.
N Open the twist locks (1) by turning
them 1/4 turn counterclockwise with
the combination wrench.
N Remove the shroud (2).
Removing the air filter
N Clean away loose dirt from around
the filter.
Chain type Pitch Minimum
groove
depth
Picco 3/8" P 0.20"
(5.0 mm)
Rapid 1/4" 0.16"
(4.0 mm)
Rapid 3/8"; 0.325" 0.24"
(6.0 mm)
Rapid 0.404" 0.28"
(7.0 mm)
Air Filter System Cleaning the Air Filter
To avoid damaging the filter, do
not use tools for removing and
installing the air filter.
To Next Page
Loading...
