39MS 460, MS 460 C
English / USA
After long period of full-throttle
operation
Allow engine to run for a short while at
idle speed so that engine heat can be
dissipated by flow of cooling air. This
protects engine-mounted components
(ignition, carburetor) from thermal
overload.
After finishing work
: Slacken off the chain if you have
retensioned it at operating
temperature during cutting work.
The chain contracts as it cools
down. If it is not slackened off, it
could damage the crankshaft and
bearings.
Storing your saw for a short period:
Wait for engine to cool down. To avoid
condensation, fill the fuel tank and keep
the machine in a dry place, well away
from sources of ignition, until you need it
again.
Storing for a long period:
See “Storing the Machine”!
Different quantities of oil are required for
different bar lengths, types of wood and
cutting techniques.
: Use the adjusting screw (1) (on
underside of machine) to vary the
oil feed rate as required.
: For average oil feed rate, set the
adjusting screw to “E“ (Ematic
position).
: To increase oil feed – turn adjusting
screw clockwise.
: To reduce oil feed – turn adjusting
screw counter-clockwise.
Your chain must always be wetted
with a film of lubricant.
Machines with Wrap-around
Handle
These saws are equipped with an oil
pump with a higher flow rate.
In adjustment range "a" the oil tank may
run low before the saw runs out of fuel
and cause the chain to run dry.
: To avoid this problem in adjustment
range "a", refill the oil tank after
using about half a tankful of fuel.
Oil Quantity
Control
001BA157 KN
1
a
001BA156 KN
To Next Page
Loading...
