Stihl MS 460 User Manual

42
English / USA
MS 460, MS 460 C
If there is a noticeable loss of engine
power:
: Clean the felt prefilter (1).
After cleaning the prefilter several times:
: Separate the filter components.
: Knock the HD filter (2) out on the
palm of your hand and blow it out
with compressed air from the inside
outward.
In case of stubborn dirt or sticky filter
fabric:
: Wash filter with STIHL universal
cleaner or in a fresh, non-flammable
solution (e.g. warm soapy water).
: Rinse the filter, from the inside
outward, under a low-pressure
water jet – do not use a high-
pressure washer.
: Dry all parts of the filter. Do not
expose to high temperatures.
: Fit the felt prefilter (1) over the HD
filter (2) - note correct installed
position (see ilustration).
: Install HD filter (with felt prefilter)
and carburetor box cover.
: Check carburetor setting and
readjust if necessary.
The felt prefilter helps protect the HD
filter and thus extends its useful life.
For this reason the felt prefilter should
be replaced at more frequent intervals
than the HD filter.
Always replace a damaged filter.
Cleaning HD Filter
2
1
176BA005 KN
176BA006 KN
176BA007 KN
2
1

Stihl MS 460 Specifications

General

Chain Pitch	3/8"
Engine Power	4.4 kW (6.0 bhp)
Displacement	76.5 cc
Weight	6.6 kg
Guide Bar Length	40-63 cm (16-25 inches)