Stihl MSE 250 C - Cutting Attachment; Components of Cutting Attachment; Matching Components

MSE 250 C
English
17
The backcut must be continued on the
opposite side of the trunk.
Ensure that the second cut is at the
same level as the first cut.
N Engage the bumper spike behind
the hinge and use this as the
rotation point – reposition the
machine as little as possible
N Tip of the guide bar must penetrate
the wood before the holding wood
(4) – guide machine absolutely
horizontally and swivel as widely as
possible
N Make the backcut up to the
hinge (5)
– Do not cut into the hinge
N Make the backcut up to the holding
wood (6)
– Do not cut into the holding wood
Immediately before felling the tree, give
out a second warning cry of "timber!".
N Cut through the holding wood at an
angle from above with arms fully
extended
A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the chain saw.
– The pitch (t) of the saw chain (1),
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
– The drive link gauge (2) of the saw
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
001BA268 KN
Cutting Attachment
001BA248 KN
1
2
3
a