MSE 250 C
English
27
If the groove is not at least this deep:
N Replace guide bar
Otherwise the drive links will grind
against the base of the groove – the
bottoms of the cutters and the tie straps
will not lie against the bar.
N Use a dry brush or similar tool to
clean the cooling slots at regular
intervals – see "Maintenance
Chart".
For periods of 3 months or longer
N Disconnect the plug from the wall
outlet.
N Remove the saw chain and guide
bar, clean them and spray with
corrosion inhibiting oil.
N Thoroughly clean the machine,
especially the cooling air inlets.
N If you use a biological chain and bar
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
N Store the machine in a dry and
secure location – out of the reach of
children and other unauthorized
persons.
Picco 3/8“ P 5.0 mm
Rapid 3/8“; 0.325“ 6.0 mm
Rapid 0.404“ 7.0 mm
Motor Cooling
Storing the Machine
To Next Page
Loading...
