MSE 250 C
English
25
N Release the trigger switch (2) so
that it can return to the off position.
It is locked in this position by the
trigger switch lockout (1).
The coasting brake brings the chain to a
standstill.
WARNING
The coasting brake operates
immediately only if the trigger switch is
fully released. If you release the trigger
switch slowly or only partly, the saw
chain will continue to run for several
seconds.
N Move hand guard to ƒ – the chain
is locked.
During longer work breaks – disconnect
the plug from the wall outlet.
When the machine is not in use, store it
in such a way that it does not endanger
others.
Secure it against unauthorized use.
The overload cutout interrupts the power
supply to the saw in the case of
mechanical overload due to, e.g.
– excessive feed force
– "lugging down" the motor
– pinching the saw chain in the cut
If the overload cutout has interrupted the
power supply:
N Pull the guide bar out of the cut.
N If necessary, disengage the chain
brake – see "Chain Brake".
N Wait for the overload cutout to cool
down.
N Depress the reset button (1) as far
as stop – if the motor does not run
when you switch on, the overload
cutout has not yet cooled down
sufficiently – wait a while and then
depress the reset button again as
far as stop.
When the motor restarts:
N Run the motor off-load for about
15 seconds. This cools the motor
and helps prevent the overload
cutout from tripping again.
Switching Off
Overload Cutout
To Next Page
Loading...
