Stihl MSE 250 C - Closing the Tank Cap

MSE 250 C
English
21
N Filling Up with Chain Oil
Closing the Tank Cap
Grip must be vertical:
N Fit the cap – marks on tank cap and
oil tank must line up.
N Press the cap down as far as stop.
N While holding the cap depressed,
turn it clockwise until it engages in
position.
The marks on the cap and oil tank are
then in alignment.
N Fold the grip down.
Tank cap is locked.
If the tank cap cannot be locked in the oil
tank opening
Bottom of cap is twisted in relation to
top.
N Remove the cap from the oil tank
and check it from above.
N Place the cap on the opening and
rotate it counterclockwise until it
engages the filler neck.
N Continue rotating the cap
counterclockwise (about a quarter
turn) – this causes the bottom of the
cap to be turned to the correct
position.
N Turn the cap clockwise and lock it in
position – see section on "Closing
the Tank Cap".
001BA252 KN
001BA253 KN
001BA254 KN
001BA235 KN
001BA255 KN
Left: Bottom of cap is twisted –
inner mark (1) in line with
outer mark.
Right: Bottom of cap in correct posi
-
tion – inner mark is under the
grip. It is not in line with the
outer mark.
1
001BA238 KN
001BA256 KN