RE 108, RE 118, RE 128 PLUS
English
11
nameplate ampere rating. If in doubt,
use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
Appropriate extension cords are
available in special stores for electrical
equipment or from your STIHL dealer.
Connection to the power supply
socket
Before connection to the power supply,
check that the machine is switched off –
see "Switching off the machine"
N Swivel the lower holder upward and
remove the power cord
N Plug the power cord or extension
cord into a properly installed outlet
N Turn on water supply
N Completely unroll the high-pressure
hose
N Turn the master switch to I – now
the machine is in standby mode
Actuating the spray gun
N Point the spray gun at the object to
be cleaned – never at persons!
N Point the rotary nozzle downwards
when starting (if fitted)
N Press the safety latch (2) downward
– the lever (1) is unlatched
N Squeeze the lever (1)
The motor stops when the lever is
released.
Standby mode
Cord length (ft) Wire gage (AWG)
50 16
100 14
150 12
Switching On
The machine may only be
switched on when the water intake
hose is connected and the water
supply has been turned on.
Otherwise the machine may be
damaged due to lack of water.
Working
The machine must not be
operated in standby mode for
more than 5 minutes. If work is
interrupted for more than 5 min.,
during breaks or if the machine is
left unattended, switch off the
machine at the master switch –
see "Switching off the machine".
To Next Page
Loading...
