Stihl RE 150 User Manual

NOTICE
■ If the pressure washer does not suck in water,
the pump may run dry and the pressure
washer may be damaged.
►
If no water escapes from the high-pressure
hose after two minutes: Switch off pressure
washer and check water supply.
►
Switch off pressure washer.
► Connect the spray gun to the high-pressure
hose.
► Press and hold down spray gun trigger.
► Switch on pressure washer.
9 Connecting the pressure
washer to the power supply
9.1 Connecting the pressure
washer to the power supply
1
3
4
2
0000-GXX-9866-A0
► Turn the rotary switch (1) to the 0 position.
► Swivel lower holder (2) downwards.
► Remove connecting cord (3).
► Plug the plug (4) of the connecting cord into a
correctly installed socket.
10 Switching the pressure
washer on and off
10.1 Switching on the pressure
washer
When the pressure washer is switched on, volt‐
age fluctuations may occur under unfavourable
mains conditions. The voltage fluctuations can
affect other connected power consumers.
Observe mains impedance,
19.
0000-GXX-4357-A0
► Turn the rotary switch to the I position.
10.2 Switching off the pressure
washer
0000-GXX-4358-A0
► Turn the rotary switch to the 0 position.
11 Operating the pressure
washer
11.1 Holding and controlling the
spray gun
0000-GXX-4359-A0
► Hold the spray gun by the handle with one
hand, wrapping your thumb around the han‐
dle.
► Hold the spray lance firmly with your other
hand, wrapping your thumb around the spray
lance.
9 Connecting the pressure washer to the power supply English
0458-603-0121-B 15

Stihl RE 150 Specifications

General

Maximum Pressure	150 bar
Operating Pressure	135 bar
Max. Pressure	150 bar
Max. Water Temperature	60 °C
Power Cable Length	5 m
High-Pressure Hose Length	9 m