Stihl RMA 460 - Inserting and Removing Activation Key; Inserting the Activation Key; Removing the Activation Key; Removing and Fitting the Battery

0458-796-9921-A
15
English 7 Assembling the Lawn Mower
► Open the side discharge flap (1) and hold it in position.
► Swing the chute (2) upwards and lift it away.
► Close the side discharge flap (1).
7.5 Fitting and Removing the Blade
7.5.1 Mounting the Blade
► Switch off the mower, remove the activation key and
battery.
► Stand the mower on end.
► Fit washer (1) on the screw (2).
► Coat screw (2) with Loctite 243 or Loctite 242.
► Fit the blade (3) so that the lugs on the mounting face (4)
engage the recesses in the blade.
► Fit the screw (2) together with the washer (1).
► Use a piece of wood (4) to block the blade (3).
► Tighten down the screw (2) firmly.
7.5.2 Removing the Blade
► Switch off the mower, remove the activation key and
battery.
► Stand the mower on end.
► Use a piece of wood (2) to block the blade (1).
► Take out the screw (3).
► Remove the washer (4).
► Remove the blade (1).
2
1
0000-GXX-4637-A0
3
2
1
0000-GXX-4793-A1
3
4
2
0000-GXX-5562-A0
2
1
3
4
1
0000-GXX-4794-A0