0458-796-9921-A
25
English
20 Troubleshooting
Mower blade resistance is
too high.
► Increase cutting height:
► Switch on mower in low grass.
Mower cuts out
during operation.
3 LEDs glow red Mower is too hot. ► Remove the activation key.
► Remove the battery.
► Allow mower to cool down
► Clean the mower
► Do not switch the mower on and off too often in
quick succession.
► Walk forwards at a slower rate.
► Increase cutting height:
► Mow lower grass.
The blade is blocked. ► Remove the activation key.
► Remove the battery.
► Clean the mower
There is a electrical
malfunction.
► Remove battery and insert it again.
► Switch on the mower.
Mower runtime is too
short
Battery not fully charged. ► Fully charge the battery.
Normal battery life has
been exceeded.
► Replace the battery.
Charge process does
not start when
battery is inserted in
the charger.
1 LED glows red. Battery too hot or too cold. ► Leave battery in the charger.
Charge process starts automatically as soon as
permissible temperature range is reached.
Condition LEDs on Battery Cause Remedy
To Next Page
Loading...
