EasyManuals Logo

Stihl RMI 632.1 User Manual

Stihl RMI 632.1
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
EN
79
0478 131 8354 D - EN
Message:
1100 – Control panel
Control panel removed during travelling
Possible cause:
Control panel has been removed during
automatic operation
Remedy:
Confirm the message with OK –
automatic operation resumes once the
control panel has been inserted
Message:
1120 – Hood blocked
Check hood
then press OK
Possible cause:
Permanent collision detected
Uneven areas around or underneath
docking station floor plate
Remedy:
Free robotic mower, remove obstacle or
change routing of perimeter wire if
necessary – then confirm message with
OK
Check movement of hood and confirm
message with OK
Level out uneven areas and confirm
message with OK (Ö 9.1)
Message:
1125 – Remove obstacle
Check wire routing
Possible cause:
Perimeter wire routed inaccurately
Remedy:
Check routing of the perimeter wire,
check clearances using the
iMOW® Ruler (Ö 12.5)
Message:
1130 – Stuck
Free iMOW®
then press OK
Possible cause:
Robotic mower has become stuck
Drive wheels are spinning
Remedy:
Free robotic mower, level out mowing
area or change routing of perimeter
wire if necessary – then confirm
message with OK
Clean drive wheels, if necessary
prevent operation during rain – then
confirm message with OK (Ö 11.11)
Message:
1135 – Outside
Place the iMOW® on the mowing area
Possible cause:
Robotic mower is located outside
mowing area
Remedy:
Return robotic mower to mowing area
Message:
1140 – Too steep
Check wire routing
Possible cause:
Tilt sensor has detected slope
inclination exceeding 22°
Remedy:
Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 22°
Message:
1160 – Handle actuated
Press OK to release
Possible cause:
The robotic mower has been lifted by
carrying handle
Remedy:
Confirm the message with OK
Message:
1170 – No signal
Switch on docking station
Possible cause:
Docking station is switched off
No reception of wire signal during
operation
Robotic mower is located outside
mowing area
Docking station or electronic
components were replaced
Remedy:
Switch on docking station and give
mowing command
Check power supply to docking station
Check LED on docking station – the red
LED must be permanently illuminated
during operation (Ö 13.1)
Return robotic mower to mowing area
Link robotic mower and docking station
(Ö 11.15)
Message:
1180 – Dock iMOW®
Automatic docking
not possible
Possible cause:
The docking station was not found

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stihl RMI 632.1 and is the answer not in the manual?

Stihl RMI 632.1 Specifications

General IconGeneral
BrandStihl
ModelRMI 632.1
CategoryLawn Mower
LanguageEnglish

Related product manuals