Stihl RMI 632.1 User Manual

EN
81
0478 131 8354 D - EN
Message:
2032 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery during charging
too low or too high
Remedy:
– Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery
Message:
2040 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery when starting
mowing operation too low or too high
Remedy:
– Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery (Ö 6.4)
Message:
2050 – Adapt mowing plan
Extend active times
Possible cause:
– Active times have been
shortened/deleted or the mowing
duration has been extended – the
stored active times are insufficient for
the necessary mowing operations.
Remedy:
– Extend the active times (Ö 11.7) or
shorten the mowing duration (Ö 11.7)
Message:
2060 – Mowing completed
Press OK to release
Possible cause:
– Mowing in secondary area successfully
completed
Remedy:
– Return robotic mower to mowing area
and dock to charge battery (Ö 15.7)
Message:
2070 – GPS signal
No reception at edge
Possible cause:
– The entire edge of the mowing area is in
a dead spot
Remedy:
– Repeat edge following (Ö 11.13)
– Contact a STIHL specialist dealer for a
detailed diagnosis
Message:
2071 – GPS signal
No reception at starting pt. 1
Possible cause:
– Starting point 1 is in a dead spot
Remedy:
– Change the position of starting point 1
(Ö 11.14)
Message:
2072 – GPS signal
No reception at starting pt. 2
Possible cause:
– Starting point 2 is in a dead spot
Remedy:
– Change the position of starting point 2
(Ö 11.14)
Message:
2073 – GPS signal
No reception at starting pt. 3
Possible cause:
– Starting point 3 is in a dead spot
Remedy:
– Change the position of starting point 3
(Ö 11.14)
Message:
2074 – GPS signal
No reception at starting pt. 4
Possible cause:
– Starting point 4 is in a dead spot
Remedy:
– Change the position of starting point 4
(Ö 11.14)
Message:
2075 – GPS signal
No reception in desired zone
Possible cause:
– The desired zone is in a dead spot
Remedy:
– Redefine the desired zone (Ö 10.)
Message:
2076 – GPS signal
Desired zone not found
Possible cause:
– The desired zone could not be found
during edge following
Remedy:
– Redefine the desired zone. Make sure
that the desired zone and perimeter
wire overlap (Ö 10.)

Stihl RMI 632.1 Specifications

General

Brand	Stihl
Model	RMI 632.1
Category	Lawn Mower
Language	English